October 14, 2019

Study shows a much cheaper catalyst can generate hydrogen in a commercial device

Replacing today’s expensive catalysts could bring down the cost of producing the gas for fuel, fertilizer and clean energy storage.

Researchers at the Department of Energy’s SLAC National Accelerator Laboratory and Stanford University have shown for the first time that a cheap catalyst can split water and generate hydrogen gas for hours on end in the harsh environment of a commercial device.

The electrolyzer technology, which is based on a polymer electrolyte membrane (PEM), has potential for large-scale hydrogen production powered by renewable energy, but it has been held back in part by the high cost of the precious metal catalysts, like platinum and iridium, needed to boost the efficiency of the chemical reactions.

This study points the way toward a cheaper solution, the researchers reported today in Nature Nanotechnology.

Graphic explaining how an electrolyzer works

"Hydrogen gas is a massively important industrial chemical for making fuel and fertilizer, among other things,” said Thomas Jaramillo, director of the SUNCAT Center for Interface Science and Catalysis, who led the research team. “It’s also a clean, high-energy-content molecule that can be used in fuel cells or to store energy generated by variable power sources like solar and wind. But most of the hydrogen produced today is made with fossil fuels, adding to the level of CO2 in the atmosphere. We need a cost-effective way to produce it with clean energy.”

From pricey metal to cheap, abundant materials

There’s been extensive work over the years to develop alternatives to precious metal catalysts for PEM systems. Many have been shown to work in a laboratory setting, but Jaramillo said that to his knowledge this is the first to demonstrate high performance in a commercial electrolyzer. The device was manufactured by a PEM electrolysis research site and factory in Connecticut for Nel Hydrogen, the world’s oldest and biggest manufacturer of electrolyzer equipment.

Photo of a commercial electrolyzer used in experiments
A commercial electrolyzer used in the experiments. Electrodes sprayed with catalyst powder are stacked inside the central metal plates and compressed with bolts and washers. Water flows in through a tube on the right, and hydrogen and oxygen gases flow out through tubes at left.

Electrolysis works much like a battery in reverse: Rather than generating electricity, it uses electrical current to split water into hydrogen and oxygen. The reactions that generate hydrogen and oxygen gas take place on different electrodes using different precious metal catalysts. In this case, the Nel Hydrogen team replaced the platinum catalyst on the hydrogen-generating side with a catalyst consisting of cobalt phosphide nanoparticles deposited on carbon to form a fine black powder, which was produced by the researchers at SLAC and Stanford. Like other catalysts, it brings other chemicals together and encourages them to react.

The cobalt phosphide catalyst operated extremely well for the entire duration of the test, more than 1,700 hours – an indication that it may be hardy enough for everyday use in reactions that can take place at elevated temperatures, pressures and current densities and in extremely acidic conditions over extended lengths of time, said McKenzie Hubert, a graduate student in Jaramillo’s group who led the experiments with Laurie King, a SUNCAT research engineer who has since joined the faculty of Manchester Metropolitan University.

Researcher with electrolyzer in SUNCAT lab
Stanford graduate student McKenzie Hubert with equipment used to test a cheap alternative to an expensive catalyst in the lab. A team led by Thomas Jaramillo, director of the SUNCAT center at SLAC and Stanford, went on to show for the first time that this cheap material could achieve high performance in a commercial electrolyzer.

“Our group has been studying this catalyst and related materials for a while,” Hubert said, “and we took it from a fundamental lab-scale, experimental stage through testing it under industrial operating conditions, where you need to cover a much larger surface area with the catalyst and it has to function under much more challenging conditions.” 

One of the most important elements of the study was scaling up the production of the cobalt phosphide catalyst while keeping it very uniform – a process that involved synthesizing the starting material at the lab bench, grinding with a mortar and pestle, baking in a furnace and finally turning the fine black powder into an ink that could be sprayed onto sheets of porous carbon paper. The resulting large-format electrodes were loaded into the electrolyzer for the hydrogen production tests.

Producing hydrogen gas at scale

While the electrolyzer development was funded by the Defense Department, which is interested in the oxygen-generating side of electrolysis for use in submarines, Jaramillo said the work also aligns with the goals of DOE’s H2@Scale initiative, which brings DOE labs and industry together to advance the affordable production, transport, storage and use of hydrogen for a number of applications. The fundamental catalyst research was funded by the DOE Office of Science.

Graphic explaining why we need hydrogen

Katherine Ayers, vice president for research and development at Nel and a co-author of the paper, said, “Working with Tom gave us an opportunity to see whether these catalysts could be stable for a long time and gave us a chance to see how their performance compared to that of platinum.

“The performance of the cobalt phosphide catalyst needs to get a little bit better, and its synthesis would need to be scaled up,” she said. “But I was quite surprised at how stable these materials were. Even though their efficiency in generating hydrogen was lower than platinum’s, it was constant. A lot of things would degrade in that environment.”

While the platinum catalyst represents only about 8 percent of the total cost of manufacturing hydrogen with PEM, the fact that the market for the precious metal is so volatile, with prices swinging up and down, could hold back development of the technology, Ayers said. Reducing and stabilizing that cost will become increasingly important as other aspects of PEM electrolysis are improved to meet the increasing demand for hydrogen in fuel cells and other applications.

SUNCAT is a partnership between SLAC and the Stanford School of Engineering. Funding for this study came from a Small Business Innovation Research (SBIR) grant from the Department of Defense. Funding for fundamental catalyst development at SUNCAT, which provided the platform for this research, is provided by the DOE Office of Science.


Citation: L. King et al., Nature Nanotechnology, 14 October 2019 (10.1038/s41565-019-0550-7)

Press Office Contact: Glennda Chui, (650) 926-4897, glennda@slac.stanford.edu

Grad student McKenzie Hubert watches electrolyzer at work
Stanford graduate student McKenzie Hubert watches a catalyst produce bubbles of hydrogen in a small lab-scale electrolyzer. (Jacqueline Orrell/SLAC National Accelerator Laboratory)

About SLAC

SLAC National Accelerator Laboratory explores how the universe works at the biggest, smallest and fastest scales and invents powerful tools used by researchers around the globe. As world leaders in ultrafast science and bold explorers of the physics of the universe, we forge new ground in understanding our origins and building a healthier and more sustainable future. Our discovery and innovation help develop new materials and chemical processes and open unprecedented views of the cosmos and life’s most delicate machinery. Building on more than 60 years of visionary research, we help shape the future by advancing areas such as quantum technology, scientific computing and the development of next-generation accelerators.

SLAC is operated by Stanford University for the U.S. Department of Energy’s Office of Science. The Office of Science is the single largest supporter of basic research in the physical sciences in the United States and is working to address some of the most pressing challenges of our time.

Dig Deeper

Related stories

News Brief

A SLAC study shows a process called atomic relaxation offers a new way to explore quantum states in these puzzling materials.

Light blue wavy lines on a maroon red background.
News Feature

SLAC partners with five national labs and eight universities seeking to increase the supply diversity of EV batteries and relieve supply chain concerns.

SLAC-Stanford Battery Center
News Feature

An associate scientist at SSRL, Richardson studies plant growth to find ways to enhance nutrient uptake in plants, especially in challenging conditions – such...

Jocelyn Richardson
News Brief

A SLAC study shows a process called atomic relaxation offers a new way to explore quantum states in these puzzling materials.

Light blue wavy lines on a maroon red background.
News Feature

SLAC partners with five national labs and eight universities seeking to increase the supply diversity of EV batteries and relieve supply chain concerns.

SLAC-Stanford Battery Center
News Feature

An associate scientist at SSRL, Richardson studies plant growth to find ways to enhance nutrient uptake in plants, especially in challenging conditions – such...

Jocelyn Richardson
News Feature

Descamps was recognized for turning the world’s most powerful X-ray laser into a sophisticated tool for probing extremely hot, dense matter.

Adrien Descamps presents his research.
News Brief

The SLAC professor was elected to the American Physical Society in recognition of his research on ultrafast X-ray methods.

Kelly Gaffney
News Feature

An energy systems engineer, Cezar helps bridge advanced energy research and applications.

Portrait of Gustavo Cezar